Search results

What FMJ weight bullet performs best with 1:9 rifling? Carbine length, if that matters. Robin

Well, I have started my search and have to admit it is dizzying with all that is out there. I looking a a side charger, left hand, in .224 Valkyrie parts and complete. I don't understand how a complete set-up can be had for less than half the cost of parts, with everything else seemingly equal...

This started fairly recent. Many of the videos posted do not work for me, I hit on them, it appears to start and immediately returns to what it was. Is this something on my end, the NYG end or something else. The most recent is in the Club House, smart teacher thread. Robin

Well, here we go again! Army sets sights on bigger, bolder, harder hitting bullets The U.S. Army's Mysterious New 6.8mm Round Mebbe, mebbe not. Robin

I'm getting stuff ready for this winters reloading and thought with the third reloading of this batch in 6.8 SPC cases (SSA) it might be time to trim them. My book, Nosler, shows only one dimension for case length, no minimum and maximum. My cases are already below the dimension shown. I am not...

This is what I call an American Jaeger. Jaegers were short barreled hunting guns used in what is now Germany. They were usually very ornate, so I kinda Yankeed it up a bit. Robin

I just received a new upper with a stainless steel varmint barrel and where the gas port enters the bore there is a noticeable burr. You can feel it when you run a patch through, you can see it when looking down the bore. How do you folks deal with something like this, send it back, or is their...

I'm thinking about getting a .22 for some fun at the range. I like the Ruger Hunter but DAMN!!!!! Is that a lot of dough for a .22 or have I been out of the market too long?!?!? And forget the stainless model. https://www.gungenius.com/handguns/semi-auto/variation/1066574/ruger-mark-iv Even...

Free to good home, or if you have some standard .38's you don't want, I'll make up the difference. My gun Pre- +P They appear to be hand loads, nickel plated, Federal, R-P, Winchester casings. About 50

Suppose you had a good friend or relative living in another state that was moving to NY. They have an off the shelf name brand AR with all the stuff that is illegal in NY, yet considered pretty standard by the industry. They are not real knowledgable about the workings of the gun outside of...

The above pictures are hand loads using a powder new to me, Benchmark. I am at the maximum load listed in my book with this load and would like some opinion's as to the primer flattening out and is this considered excessive. Shown are three fired and one unfired to give you an idea of before and...

I made this for my wife years ago and she no longer shoots, so I decided to forgo my favorite squirrel gun, dust this off, confirm the sights and have at it. Its a .32 and if I remember correctly, 15 gr's of FFF and it zero's at fifty yards. So its off to the range. Hah, I noticed her engraved...

Another story not told by Big Media. Well written. Anarchy Breaks Out in Portland, With the Mayor’s Blessing Robin

I noticed that the photo's of A long gun I posted some time ago fell victim to those grubbers over at photo bucket, can't remember which gun it was so I show the one I made for myself. .50, Lehigh Valley style architecture, my favorite. Robin

Anyone interested in Archery around the Genesee Valley region should pay a visit to the Avon Bownens Club. Practice range with targets from 10 to 80 yards, and three ranges of 14 targets each that wind their way through a beautiful hardwood forrest. You don't even have to be a member to shoot...

What a waste of air, literally and figuratively. Maher: I'm "Hoping" For "A Crashing Economy" So We Can Get Rid Of Trump, "Bring On The Recession" Robin

Anyone else going out Tuesday? Getting psyched!!! Robin

A new concept in ammo, well not totally new but interesting all the same. New Experimental Army Rifle Uses "Telescoped" Ammunition Robin

Looking for pure lead, wheelwrights, linotype, etc. won't do. I'm getting down low in my lead cache and I'm looking for a source in the Livingston county, Rochester area. Any of you guys do any remodeling for Doctors and Dentists? That lead shielding from the X-ray room is the best, pure, dead...

https://taskandpurpose.com/army-next...-squad-weapon/ Interesting article, and it sounds like everything is set but the ribbon cutting. Robin

What is a good holster for a concealed cary at the four o'clock, or kidney cary. I'm kind of lean and would like something thin. Robin

Why is this forum so slow to react to everything. I'l hit 'create thread' and it will probably take a half minute or more to complete. Its been going on, off and on for a week!!!! Robin

Seven of them all to gather a moment ago. Pretty cool!! Robin

Turkey decoy's to be specific. I have been using inflatables because they pack small and I like to rove quite a bit, especially towards the end of the season, and I like to travel light. I only carry three, two hens and a jake, and don't always set out all three. It seems every year one or two...

Radio news reported this morning that there was a shortage of fresh produce in the Rochester area due to the east coast storm last week. Just goes to show how vulnerable the food chain is when a one day storm has that kind of impact. Check your stuff and update as needed. Robin

I have a 6.8 and after a lot of thought I decided to put my money into building an upper assembly rather than going for an AR-10 in .308, been chewing on this for a long time, it feels like a relief to have finally made up my mind. Now that I'm reloading again I want to see what kind of...

This is what I call the Greyhound of long rifles, smooth and trim in architecture and transition points, very difficult to get right. I still don't completely understand their style of engraving and carving but its a fairly good representation for that area of gun making known in the gunmaking...

She is suing the government to repress what rightfully belongs to We the People. Lois Lerner Demands Secrecy for IRS Targeting Lawsuit Deposition The only benefits this socialist hag should be receiving is room and board at a federal penitentiary. Blatant crimes from within an agency that...

I saw this ad on television last night, right here in NY, and could not believe what I was seeing and hearing. Speechless. Robin

Yesterday We installed a Motorola modem router combo. now, when I go to my bookmarks and hit NYGF it comes up but is a half page with some kind of error, the box for forums is there so I hit that and the home page comes up but I no longer have that red count number over the alerts. I logged out...

Anyone else receive this magazine? This months issue contains an article on lead ammo and how terrible it is. This is how it starts, you can place a sure bet that soon we will not be allowed to use lead bullets. There is even a line in the article: This as a result of the SAFE Act, for you...

I always keep my brands of brass separate, finished up recapping some SSA brass and started in on the Hornady. The primers were going in a bit difficult and after about four or five they were sheering the caps and leaving a burr from the cap sticking out. So I take apart my capping tool clean...

Avon Bowmen 3-D shoot this Sunday!!!!! Last one of the year, come on out and enjoy 30 realistic 3-D targets on two fifteen target courses that wind through a beautiful hardwood forrest. You can compete or just shoot for the fun of it. $15.00 adults, $5.00 kids, 2900 Pole Bridge Road in AVON...

Great day for me, five shot group, blew up a bunch of milk jugs shooting off hand at 50 and 100 yards! Nice overcast, perfect shooting light for iron sights.

Everytown Takes Victory Lap as Paul Ryan Lets National Reciprocity Stall

Would this gun be legal in NYSSR? Hakim Rifle - Wikipedia From what I understand, it is C&R eligible, not that I have that permit, but wouldn't that make some features allowable? Robin

Guard units seeking to confiscate a cache of recently banned assault weapons were ambushed on April 19th by elements of a paramilitary extremist faction. Military and law enforcement sources estimate that 72 were killed and more than 200 injured before government forces were compelled to...

Well now, they have legalized even more corruption, the unions can dump even more money into the progressive slush fund and guess who 'actually' pays for it. Yes, you guessed it, we the non-union tax payer. That's just one feature of this clusterfuck of unfunded mandates that will further...

Having returned to reloading, and enjoying it, I am in search of a touch more precision, so I'm thinking about getting a chronograph. I'm only loading for two rifle calibers at present, the 8 mm Mauser, and the 6.8 SPC AR with a 16" barrel, this is the one I am more interested in developing. I...

Action Alert from SCOPE! This is an Action Alert from SCOPE asking you to invest a few minutes and make your voice heard. David Please plan on attending this rally where a monumental announcement will be made concerning The Un-Safe Acts Demise! Forward this email statewide for maximum...

As seen 7 rounds of 30-30, core-loct, Remington's. Spring cleaning and found these, for another gun I sorely regret selling about forty years ago, Ah me. So if you live anywhere close enough (Avon) to make the drive worth it they are yours free. Robin

I'm back at reloading after a long absence thanks to this crap hole state. Most of my reloading was straight sided pistol cartridges and some 250-300 Savage, not much of those though. Now all I am reloading is rifle, my cartridges have been tumbled, I have cleaned the inside of the neck with a...

Anyone want to go in on a group buy for reloading powder and safe on the onerous fee's? Avon, Livingston county, southern Monroe county area, or anywhere near. FUAC! Robin

In the original box with owners manual. I think it needs a new seal, not a big deal from what I understand. Robin

I don't know anything about these things. It has 1943 on the outside of the chamber along with the hammer and sickle. Bore is terrible. This is something I picked up years ago and realize it is a project I will never get to, so, spring cleaning, g'bye. Don't know what transfer fees are but you...

WTF! Police state anyone? UPDATE: Livingston County prepping MRAP armored vehicle; Sheriff cites need to protect personnel Robin

Is the Gamo Whisper worth the money? Gamo Whisper Silent Cat, .177 cal | Airgun Depot I'm not looking for a high end gun, just something That is not junk and will last, the two are not always one in the same. The rabbits are chewing through the not so invisible dog fence wire and they need...

Now bear with me here, we have every deviant, pervert, and butt hurt asshole in the country suing some one over some supercilious something that offends their own particular warped stupidity. So, why can't we as a group of individuals file a class action law suit against the bulk distributers of...

What with The NYAG giving advise to cities, town, and individuals on how to violate federal statutes with regard to harboring illegal aliens, how is it that he is not being arrested for 'conspiracy' in the least and even more harsh charges in the active participation in breaking federal laws...

I believe it is the only one ever made. Robin